Ricoh Savin SLP6C, Operating Instructions Manual

Page: 52 / 140

Troubleshooting
40
4
*1
This message appears when the optional duplex unit is installed to the printer.
Note
❒
If you cannot solve the problem by taking the above actions, turn the printer
off and on. If this does not clear the error message, write down the error num-
ber and the message, and contact your sales or service representative.
B7: Error An error has occurred in the
optional Network Interface
Board. Turn the printer off and on.
Then, try to print again.
Turn off the printer. Re-
move and reinstall the Net-
work Interface Board and
turn on the printer. Then,
try to print again.
Turn off the printer. Re-
move the Network Inter-
face Board from the printer
and turn on the printer.
Then, try to print again.
Note
❒
If you remove the Net-
work Interface Board,
you cannot print via the
network. You can send
the print job to the print-
er only via a parallel ca-
ble connection.
85:Error The printer has run out of
frame memory. There is not
enough memory to render the
graphic data. Reduce the size of the input
buffer, or add optional
memory.
86:Error You may be trying to print with
the wrong printer driver. Confirm that you are using
the correct printer driver.
You might not be using the cor-
rect interface cable. Confirm that you are using
the correct interface cable.
91:Error An error has occurred in the
printer's standard memory. Turn the printer off and on.
Then, try to print again.
94:Error The amount of the memory is
not set correctly. Specify the correct amount
of memory using the print-
er driver.
Message Description Comments