Ricoh Pro 8300S, Troubleshooting Manual, Page: 38 / 963

1.SC Codes
30
When a type D occurs, automatic reboot is done or the machine display asks the customer if it can
reboot. However, when the SC occurs twice in a short time, the machine sends a report to the
@Remote server without rebooting. This is because just rebooting may not be a good solution if an SC
occurs twice.
When an automatic reboot is performed, a confirmation screen is displayed after reboot. The
confirmation screen can be cancelled by pressing the [OK] key (display is not cancelled only when the
main power switch is switched OFF to ON).
Screen display during reboot
 Status display on the current screen
 Post-processing ...... Post-processing during printing, etc.
 Automatic reboot .... After operation end
Post-processing
Until automatic reboot
 Reset key (Reboot key)
Key to perform reboot
# Cancel key is not displayed.
 Turn ON spanner LED (same as when an SC is generated).
Operation during SC reboot
 Timing of SC reboot
When @Remote is enabled, and when a NRS alarm*1 is not generated, the corresponding SC is
the object of an automatic reboot.
*1 NRS alarm: Issued when an ordinary SC (type D) is generated twice while the total counter
counts 10 times.
 Time to automatic reboot
Reboot is performed 30 seconds after an engine reboot is possible, after the end of post-
processing during printing, etc.
At that time, a reboot is performed even if the MFP is operating. The engine does not start process
control when a reboot is possible.
 Automatic reboot
See the flowchart below.