Ricoh LDD250, Service Manual

Page: 350 / 459

MASTER EJECT
C262/C265 6-28 SM
Master Eject and Transportation
The master pick-up roller [A] and the upper and lower master eject rollers [B] all
turn together. They start turning as soon as the drum reaches the master eject
position.
The rollers stop once the leading area of the master is picked up from the drum.
(The master eject sensor detects this.) Then, when the drum starts turning, they
turn on again to feed the ejected master to the eject box while the drum turns
towards the master making position.
The master eject sensor (not shown) is located just under the lower master eject
roller, and it monitors the master feeding. If the master is not properly picked up, i.e.
it does not activate the sensor; the operation panel displays a master eject jam
message.
Master Eject Roller Unit
Drive
The master eject motor [A turns
the master pick-up roller [B with
the upper and lower master
eject rollers [C.
When the unit is slid out
(explained below), the joint [D]
disengages.
C262D016.WMF
C262D513.WMF
[A]
[B]
[A
[B]
[D
[C]