Ricoh LDD250, Service Manual

Page: 179 / 459

PRINTING SECTION
C262/C265 3-104 SM
Reinstallation procedure
CAUTION: Take care not to turn the drive accidentally after removing the pressure
cylinder. When the drive is in position, the cutout (for engagement) in
the drive conductor (white disk) [A] is positioned horizontally but leans
to the upper right just slightly.
1. Hold the pressure cylinder so that the round hole [C] is uppermost. Rest the
pressure cylinder on the flat area of the inner cover [D].
NOTE: There is an encoder plate [B] at the rear of the pressure cylinder. Be
careful not to damage it when installing the pressure cylinder.
2. White the left hand, hold the bearing tightly, putting fingers into the holes as
shown.
C262R110.WMF
C262R109.WMF
[A]
[B]
[C]
[D]