Guide to Components
10
1
DIP Switches
Change only the switches No. 1 to 3. Do not change the other switches.
*1
SCAM: SCSI Configured Automatically. Protocol to set SCSI ID automatically.
Important
❒
SCSI ID will not be configured even if you set SCAM to enable, when more
than one of this scanner with the SCAM function enabled are connected to the
daisy chain. In this case, disable the SCAM by setting the DIP Switch No.1
ON, and set the SCSI ID with the Rotary Switch.
❒
The USB and the optional IEEE1394 connection cannot be used when the SCSI
synchronous transmission is set. You can turn the DIP Switch No.2 OFF (SCSI
synchronous transmission enabled) when using the scanner only with the
SCSI connection.
❒
A malfunction with SCSI synchronous transmission may occur if you use a
SCSI cable longer than recommended, or a cable out of the standard. In that
case, turn the DIP Switch No.2 ON (SCSI synchronous transmission dis-
abled).
❒
When the scanner is connected to the middle of the daisy chain, set the DIP
Switch No.3 ON.
SW No.
Function
OFF
ON
1
SCAM
*1
disable
enable
2
SCSI synchronous transmission
enable
disable
3
SCSI termination
enable
disable
4
(system usage)
always
OFF
Do not make changes.
5
6
7
8
ADC005S
Summary of Contents for IS760
