Ricoh Gim-MF1a, Field Service Manual

Page: 99 / 300

• Make sure the EEPROM is correctly installed on the BCU. Insert the EEPROM in the EEPROM slot
with the "half-moon" pointing [C] to the downside.
EEPROM on the BCU
1. Print out the SMC data (SP5-990-002, SP5-990-003).
2. Turn off the main power switch. Then unplug the power cord.
3. Replace the EEPROM on the BCU and reassemble the machine.
4. Plug in the power cord. Then turn the main power switch on.
When you do this, SC995 will be displayed. However, DO NOT turn off the main power switch.
Continue with this procedure.
5. Enter the machine serial number (SP5-811-001).
• For information on how to configure SP5-811-001, contact your supervisor or support center.
6. Set the machine state destination (SP5-996-001).
• For information on how to configure SP5-996-001, contact your supervisor or support center.
7. Turn the main power switch off and on.
• If the BCU serial number is not entered correctly, SC995-01 (serial number entry error)
appears.
8. In accordance with SMC data, specify the UP and SP mode settings.
Toner End Sensor
1. Left Cover ( page 39 "Left Cover" )
Electrical Components
97