Ricoh D454-17, Manual

Page: 114 / 164

First, compare the L2 measurements.
• In this example, imagine that L2 is longer at the front than at the rear.
• Look at the table, in the row for FM1, and the column for L2.
• ‘F Long’ means Front measurement longer than Rear
• ‘F Short’ means Rear measurement longer than Front
• L2 is longer at the front, so we have an ‘F Long’ situation.
• Then look at the next line, below ‘F Long’. It says ‘Lower F on S2’.
• This means you must lower the front end of stopper 2.
Then, compare the L3 measurements.
• In this example, imagine that L3 is longer at the front than at the rear.
• Look at the table, in the row for FM1, and the column for L3.
• ‘F Long’ means Front measurement longer than Rear
• ‘F Short’ means Rear measurement longer than Front
• L3 is longer at the front, so we have an ‘F Long’ situation again.
• Then look at the next line, below ‘F Long’. It says ‘Raise F on S3’.
• This means you must raise the front end of stopper 3.
Stopper Adjustment Procedures
1. Use the "Skew Correction Reference Diagrams" and "Skew Correction Reference Table" in the
previous section to determine the location of the skew and which stopper needs adjustment.
1. Replacement and Adjustment
112
1