Ricoh D017, Service Manual

Page: 1215 / 1271

Electrical Components
SM 59 D372
500-Sh
ee
t
Finisher
D37
2
No. Error Problem/Solution
OFF after the feed-out belt motor ran for 100 pulses.
ƒ
The feed-out belt HP sensor did not switch from OFF
to ON after the feed-out belt motor ran for 1000
pulses.
Solution:
9 Stapler movement
motor error 1
Problem:
Occurs at initialization or while the paper is being fed to
the start position in the finisher.
ƒ
The stapler HP sensor did not switch from ON to OFF
after the stapler movement motor ran for 200 pulses.
ƒ
The stapler HP sensor did not switch from OFF to ON
after the stapler movement motor ran for 5600 pulses.
Solution:
10 Stapler motor error Problem:
Occurs during staple supply to the stapler.
The stapler operation (stapling) did not end after 600 ms.
A staple jam can also cause this error.
11 Tray lift motor error Problem:
Occurs at initialization, after return to standby, or during
feed-out belt operation.
ƒ
The paper height sensor did not go OFF after the tray
lift motor ran for 3 sec. to lower the tray.
ƒ
The paper height sensor did not go OFF after the tray
lift motor ran for 20 sec. to raise the tray.
Solution:
12 Edge depressor
solenoid
Problem:
Occurs at initialization or during feed-out belt operation.
ƒ
The paper height sensor remained ON after the
solenoid went OFF.
Solution:
13 Tray full sensor Problem: