7.6 ROLL FEED PAPER SKEW ADJUSTMENT
1. Mark a line [A] on the exposure glass [B].
2. Make 594 x 1189 mm copies from the roll feeder unit.
NOTE: 594 mm wide paper is easier to adjust than 841 mm wide paper.
3. Measure the lengths [C] and [D].
4. Loosen the 2 screws [E] which determine the paper spool height.
5. If C > D, lower the right side of the paper spool. If C < D, do the opposite.
6. Make another copy. Check the lengths [C] and [D].
7. Repeat steps 4 to 6 if necessary.
NOTE: If the 10 or more copies are made continuously, the nip band
width of the fusing unit may change. For correct adjustment, do
this procedure at least 10 minutes after a continuous copy run of
10 or more.
[B]
[A]
[C]
[D]
[E]
[E]
31 October 1994
REPLACEMENT AND ADJUSTMENT
21
