7.5 CUT LENGTH ADJUSTMENT
The cut length adjustment should be done when the roll feeder is installed to
correct cutting errors. The cut error correction data is determined in the
factory without the copier installed. The cut length varies depending on the
copier on which it is installed and/or paper type used. If required, adjust the
cut length as follows:
NOTE: The cut length should be measured 10 minutes or later after copying
because the fusing unit dries the paper and reduces its length
temporarily.
7.5.1 Preset Cut : Adjustment standards:
±
3 mm (for length shorter
than 420 mm)
±
5 mm (for 420 to 1189 mm)
NOTE: There are three settings of the cut length depending on the
temperature mode. They are set in the factory to match a standard
paper type. [Normal (SP#42, 45), High (SP#43, 46), Low (SP#44,
47)].
1. Make 5 copy samples of A0 lengthwise (1189) and A3 sideways (297) in
the preset cut mode.
2. Measure the difference of the length between the each copy sample and
preset cut length (1189 and 297). Then, calculate the average difference.
3. Input the average value using SP modes #42 to 47 so that the cut length
is within the adjustment standards.
Example: 1. Current SP data #42....0
Copy sample length = 297 – 4
Set SP mode #42...4.0
2. Current SP data #42....0
Copy sample length = 297 – 4
Set SP mode #42...+ 4.0
4. Make A0 lengthwise and A3 sideways copies using preset cut mode and
check their length.
5. Repeat steps 2 to 4 if necessary.
REPLACEMENT AND ADJUSTMENT
31 October 1994
20
