17. Reinstall the rear cover (2 screws).
18. Install the angle stopper [A] (2 screws), and the original table [B].
19. Adjust the height of the magnet catch on each side. Repeat the
following procedure for each magnet catch:
1) Remove the grip cover [C] (2 screws).
2) Loosen the screws securing the magnet catch [D] (2 screws).
3) Close the document feeder and tighten the magnet catch screws
when the rubber stopper [E] contacts the exposure glass.
20. Reinstall the grip cover (2 screws).
[A]
[B]
[C]
[D]
[E]
30 November 1990
7-29
