ARTICULATED ARM OPENERS USER MANUAL
8
3. Get Started
Note:
(A) Remote memorizing must be done before system learning.
(B)
Verifying the GATE CONDITION.
1) Release the gear with the release key and move the gate to the middle so the gate can move in both opening
and closing directions; then lock the gear.
2) Operate the gate to opened and closed position several times and make sure the gates touches the limit switch at least
2~3 cm before the mechanical stop.
3.1 Step 1: Remote
Learning
3.1.1
Learning
1.
Press “RF Learn” button for 3 seconds, and the LED display shows “CS”. Then press any desired button on the remote;
the LED display will blink "CS" three times and stay on. After 7 seconds without any new remote learn then the LED will be
off The transmitter learning is completed.
Antenna
(figure 1)
(figure 1)
RF-Learn
New Remote
(Press
any
desired button
)
UP
A
B
SET
DOWN
RF-LEARN
3
Sec
R
F-L
EA
R
N
SE
T
3.1.2 Remote learning without Control board:
(1)
Press the
A & B
buttons
on the
OLD
r
emote
and hold down for at least 5s, then release
them
.
(the alarm will buzz 2
secs,
and LED will display "CS")
(2)
Press
any desired
button on the
NEW
remote
within 10 seconds
(
the alarm will buzz 3 times, LED blinks "CS" for 3
times)
Old
Remote
New
Remote
3
Seconds
A
B
A
B
Press any button
in 10
Seconds
CS
Blink 3 times
3.1.
3
Deleting all memory of all remotes:
With this operation all the memorized transmitters will be deleted.
(1)
Press and hold down RF-LEARN button (Figure 4) on the control board for 10 seconds.
(2)
Wait until the LED display shows “
CC
”. All memory
is deleted.
CC
DONE
10 Sec
RF-Learn
(figure 4)
