GTR099 swing gate opener manual – Revision 22
20
How to Program the Remote to the Opener:
You must program the remote to the opener before operating. You can follow the below steps to program the
remote to the opener.
Press and release the CODE SW button, the CODE LED will be ON, then press the key in the remote twice in 4
seconds, the CODE LED will flash for 3 seconds and then to OFF. Now the remote has been programmed
successfully.
NOTE: The button of the remote control should be pressed and hold for more than 2 seconds while programming.
Max. 10 remotes can be programmed for the opener. If you want program more remotes, you should use an
optional external receiver.
How to use the Remote to
Operate your Gate Opener:
Each remote has four buttons, from top to bottom are separately A, B, C and D.
You may use this remote to operate as many as 4 sets our swing gate opener or 1
set our sliding gate opener and 2 sets our swing gate opener.
1. Use this remote to only operate our swing gate opener A, B, C and D four
buttons share same function once they are programmed with our swing gate
opener. You may choose any button to program it with our swing gate opener.
Every press of the button is able to active the gate opener to work alternately
(open-stop-close-stop-open).
How to Erase All Remote Controls:
Press and hold the CODE SW button until the CODE LED goes from ON to OFF.
This will take approximately 8 seconds and will remove all remote memory from the gate motor.
