GTR099 swing gate opener manual – Revision 22
12
3.
Open the release hole plug on the top of the gate
opener, insert the release key, and turn the key 90°
clockwise. This releases the motor and allows the push-
pull rod to be manually extended and retracted. To
restore normal operation, turn the key 90° counter-
clockwise.
4. With the opener fully retracted and with the gate in
the fully open position (for Pull-to-Open installation) or
fully closed position (for Push-to-Open installation),
place the gate opener with the Post Bracket Assembly
and Gate Bracket on the gate post and the gate. Position
the Post Bracket Assembly and Gate Bracket so that the
gate opener is level. While holding the gate opener in the
level position, temporarily secure it with two C-clamps.
5.
Make sure that there is a minimum clearance of 2.5cm between the gate and the opener and that the opener
and the Post Pivot Bracket are not binding in both the gate-open and gate-closed positions. If there is not at least
2.5cm of clearance or if the opener and the Post Pivot Bracket are binding, rotate the Post Pivot Bracket and/or
move the Post Bracket Assembly to obtain the minimum clearance and eliminate the binding. When the minimum
clearance has been obtained and any binding has been eliminated, place the M8 x 30 bolt through the aligned holes
in the Post Bracket and the Post Pivot Bracket.
