RichAuto A11, User Manual

Page: 34 / 68

RichAuto S & T Co., Ltd
Add: 5th floor, No.4 building, No 4. Yard, life Rd, life science park, beiqing St., changping district Beijing, China
Tel
：
010-53275118 Fax
：
010-53275110/53275111 Web site
：
www.richnc.com.cn
29
The under arrow indicates the output level
：
Set output voltage signal terminal
status. The top four: 0
、
1
、
2
、
3 positions correspond spindleOn/Off
、
multi-speed 1
、
multi-speed 2
、
multi-speed 3 siganl
，
5
、
6:4
、
5 positions correspond alarm LED
、
work LED signal.
Setting
：
Press
“ ”
/
“ ”
to move around
，
Press
“ ”、
“ ”to move up and down ，
press
“ ”
to change the direction of the arrow.
8. C.A.D. Thickness
：
Unit
：
mm
This thickness should input by actual
，
if it is bigger than the actual theckness ,Z
axis may cut too much;if smaller, Z axis can’t touch workpiece. This parameter can
only take effect when user use auto toolsetting function.
9. Max Spd Limit
（
Max Speed Limit
）：
Unit
：
mm/minute
Set machine top speed, it only take effect during processing, system default
max speed X,Y is“60000000 mm/minute”, “Z+” is “1800 mm/minute”, “Z-” is “3000
mm/minute”.
10. DistTime Limit
：
Unit
：
second
Users select diatance mode,and if the machine does not move in a certain period
of time(system default is 30 seconds),the system will go back to continuous mode to
prevent Z-axis collision risk because of the customer forgot to switch back to
continuous mode and set a large distance value.
11. InputConfi
（
Input Port Configuration
）
：
To open or prohibit input signal
，
if the interface board does not connect X5-X8
signals,users can prohibit X5-X8 signals.