10
RL-42TT Operation Manual
5. Unlock the front cover piece by pushing
locks inward.
6. Lift/take off the front cover piece
according to the figure shown at the
right.
7. Plug in the stripper module’s connector
to the switchboard socket.
NOTE:
There are two sockets on the converting boards.
One is for stripper module installation, and the other is
for the cutter. Before you plug the connector into the
socket, check the pin first.
8. Place the left side of the stripper module
first, then fit the right side.
9. Hold the stripper module in place and
tighten the screws to secure its location.
Summary of Contents for RL-42TT
Page 1: ...108223 RL 42TT Thermal Printer Operation Manual 108223...
Page 2: ......
