Page
16
/
29
4.3- Assembly
4.3.1- All models, except PRSPOT32P
Before installation
•
Install the floodlight permanently on a strong support, such as wall, masoney pillar, with
following the installation instructions.
•
Do not mount the product or any parts on mast, stand or tripod.
•
Ensure a ventilation distance of greater than 0,5 metre is allowed between the luminaire and
adjacent objects. See Fig. 4 for examples.
•
A mounting height of 2,3 - 3 metres above the ground is recommended.
Models WITHOUT motion sensor
Models WITH motion sensor
Fig. 4
Installation of the LED floodlight
•
Refer to Table 2 for the measurements of mounting bracket, then determine and mark the
fixing hole position.
•
Make holes with power drill, then install the floodlight in location with provided screws.
Ensure the method of fixing can support up to a 10 kg weight.
•
Adjust the spotlight and sensor to the desired position, then tighten the screws.
4.3.2- For model PRSPOT32P
Installation of stand (7)
•
Remove the knob (9) and washers from the stand (7) assembly.
•
Place the floodlight on the stand with the backet (4) center hole aligning with the knob hole.
•
Restore the knob and washers and fix the floodlight on the stand by tightening the knob.
4.4- Adjusting the floodlight inclination
•
Lossen the 2 nuts on each side of the mounting bracket.
•
Adjust to the desired inclination.
•
Tighten the 2 nuts firmly.
•
CAUTION!
Adjust the inclination so that the luminous flux does not disturb others.
