Page
14
/
29
IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging.
•
Check if the product and accessories (if any) are intact.
4.2- Electrical connection
WARNING!
Before any intervention on product, ensure that switch in set to “OFF” position or
the product is disconnected from its power source.
4.2.1- For models WITHOUT power cord
Cable preparation
•
Electric cable of H05RN-F 3G1.0mm
2
is
recommended to this product.
•
At both ends of the electric cable, strip the wires as
Fig. 2.
Fig. 2
Connecting the cable to the luminaire housing (Fig. 3)
•
Remove the cable gland (a) from the elbow connector (c) to access the terminal block (d) for
electrical connection.
•
Unscrew the cable gland’s lock nut (a) from the gland (b).
•
Insert the power cord (e) through the lock nut (a) and then the cable gland (b).
•
Connect the wires (blue, brown, green / yellow) of the power cord (e) to the terminal block
(d), taking care to respect the wires color codes: blue with blue; brown with brown, and
green/yellow with green/yellow.
•
Leave the required length of electrical cable inside and then replace and screw the cable
gland (b) firmly onto the elbow connector (c).
•
Pull the cable slightly, replace the lock nut (a) on the cable gland (b) and tighten firmly.
•
NOTE:
If your main wiring differs from below illustration, consult local qualified
electrician.
Models WITHOUT motion sensor
Models WITH motion sensor
