40
CASING MOUNTING
- Mount the fixed handle (without release warning) on the casing using the screws, bolt and washer supplied, inserting them
on the opposite side to the release device (Fig. 38).
- Apply the cap on the side of the operator where the driving shaft if not sticking out (Fig. 45).
- Connect the illuminator unit connector to the cable leading from the electrical switchboard (Fig. 39 and 40).
- Insert the casing on the reducer, making sure to position it on the mounting plate in the appropriate position and centre the
release spar with the predrilled holes on the casing. Fasten the casing to the motor with the screws supplied (Fig. 42 and
43) and then fix the release device handle (Fig. 44) to the motor release device spar.
- Apply the lateral cap (Fig. 46).
The operator is now installed and ready to carry out tutoring programme operations (refer to PROGRAMMING section).
38
45
46
G
B
39
40
41
42
43
44