6
Digital Type Keypad (KP-603) for RM6
Operation of Keypad
Display panel
Blinking: Under acceleration
or deceleration
ON: Constant speed
OFF: Stop
Drive start key
Up/down key of changing
functions and parameters
1. Drive stops(cut off output
frequency of drive)
2. Fault reset
1. Enter parameter setting mode
2. Back to function setting mode
3. Switch monitor mode
1. Enter function setting mode
2. Back to monitor mode
Unit indicator
Pot knob
1. ON: Primary frequency
command is set by
keypad or UP/DOWN
terminal
2. OFF: Primary frequency
command is set by
multi-function input
terminals
The operation of the digital keypad includes fault messages and three modes. The switching
methods are shown as below figure:
Monitor mode
Function setting mode
Parameter setting mode
Fault message
FUN
DATA
PROG
FUN
DATA
STOP
RESET
PROG
PROG
KEYPAD
Hz
V
A
KEYPAD
Hz
V
A
KEYPAD
Hz
V
A
KEYPAD
Hz
V
A
*When the keypad is idle for three minutes at
“
function setting
mode
”
or
“
parameter setting mode
”
, drive will switch back to
the
“
main display
”
.
The operation steps are shown as below table (by default setting)
Operation Steps
Display
1.Start the drive and enter the monitor mode.
KEYPAD
Hz
V
A
2.Press
PROG
key and enter the function setting mode.
KEYPAD
Hz
V
A
3.Press
FUN
DATA
key and enter the parameter setting mode.
KEYPAD
Hz
V
A
4.Press
FUN
DATA
key and return to the function setting mode.
KEYPAD
Hz
V
A
5.Press
PROG
key and return to the monitor mode.
KEYPAD
Hz
V
A
