Rhosonics SDM Series, Manual

Page: 42 / 65

SDM – Slurry Density Meter
42 www.rhosonics.com
CONFIGURATION
Setting Low and High value

Open Map Signal condition (Online

Device Setup

Detailed setup

Signal condition)

Set value for PV LRV (i.e. SGx1000 = 800)

Set value for PV URV (i.e. SGx1000 = 1800)
Low and High value 4-20 mA output
Setting Analog output condition

Open Map Signal condition (Online

Device Setup

Detailed setup

Output
condition

Analog output)

Set mode for PV Alrm typ (choose from Hi, Lo, Hold last value or None)

Set Loop current mode to Enabled

Use D/A trim to fine-tune the 4 mA and 20 mA value digitally. After this trim a power down and
power up must be done.
Analog output condition