RHODE INOX 100, Manual Instruction, Page: 8 / 10

RHODE UVC 2020.02.01 Page8

Install new radiators in the same place.

Mount the cover (2) to the housing (1).

Turn on the sterilizer's power supply.

Reset the radiator operating time counter.
EXTERNAL RADIATORS

Remove the radiators from the catches and disconnect their two-pin shafts from electrical holders.

Install new radiators in the same place.

Turn on the sterilizer's power supply.

Reset the radiator operating time counter (see section - programmer operation).
ATTENTION :
Replacement of the sterilizer radiators must be carried out by a qualified electrician.
Do not turn on the sterilizer with the casing removed.
Turning on the power of UV-C lamps can damage your eyes!
11.3 ANTI-DUST FILTER REPLACEMENT

The device is equipped with an air filtration system consisting of a dust filter.

Turn off the device and unplug the power cord.

Remove used (dirty) filters from the holders.

Replace with new filters.

Mount the filter covers.
11.4 FUSE REPLACEMENT

Turn off the device and unplug the power cord.

Open the fuse cover with a flat screwdriver.

Remove and replace the fuse.

Za pomocą płaskiego śrubokrętaotwórz pokrywkę bezpiecznika.

Wyjmij i wymień bezpiecznik.

Close the fuse cover and secure it against opening by lightly pressing until it stops.
Attention:
Do not use fuses with a value higher than the permissible value. (2 A).
Fuses must not be regenerated.
12. HEALTH AND SAFETY ISSUES

Make sure that the mains voltage is correct, i.e. 230V / 50Hz and that the electrical power socket has a
grounding prong.

Do not use the sterilizer in rooms with high humidity or near heat sources.

Do not allow children or unauthorized personnel to manipulate the device.

Avoid twisting, stretching or bending the power cord excessively.

Do not immerse the device in any liquid.

Do not carry out maintenance work under the influence of alcohol or other drugs.

Do not exceed the service life of the radiators.

Do not allow excessive filter contamination.

Do not block the inlet and outlet openings on the device.
Attention:
UV-C radiation is harmful for skin and eyes!
Do not switch on UV-C lamps with the casing removed
.