12
INSTALLATION INSTRUCTIONS
Installation of Rhino
®
Pro-Series
™
Ex-
tended Handles:
1. Loosen the two HEX bolts (4 mm Hex
Wrench) on the throttle.
Do Not Remove Them.
2. Remove the air filter cover on the
Honda GX35 engine. Using two 10mm
wrenches loosen the throttle cable retain-
ing nuts.
3. Disengage the throttle cable from the
carburetor throttle control linkage.
4.Cut the wire ties holding the wire to
the throttle cable and disconnect the wire
harness.
5. Mark the top side of the handle collars
with a black marker or alike as they are
specific on which way they are installed.
6. Remove the two 5/16” Socket Head Cap
Screws (1/4” HEX wrench) recessed in the
top handle assembly.
The handle collars are
under tension from
the handle springs and could cause injury
from recoil.
7. Remove the two 5/16” Socket Head Cap
Screws (1/4” HEX wrench) recessed in the
lower handle assembly.
If you have an earlier model
that does not have a removable
lower handle assembly you will need to
remove the four 5/16” HEX bolts (1/4”
wrench) in the top handle bracket and set
aside to allow the throttle to be removed
from the side handle assembly.
* Please
note you will need to order a lower handle
(Part no. 301233) if your Pro-Series Driver
model does NOT already have one. DO NOT
OPERATE EXTENDED HANDLES WITHOUT A
CONNECTING LOWER HANDLE.
8. Slide the side handle assembly down
removing the throttle as it is slid through
the lower body.
9. Using a ¼” Socket remove the ground
screw. Retain the ground screw to be
reused when re-assembling.
10. Coat the 5/16" Socket Head Cap
Screws (see step 7) with Loctite Primer
7649 and allow to dry. Use the new screws
provided with the extended handle acces-
sory, do not use the original screws from
the handles as they may have wear on the
threads.
11. Spray Loctite Primer 7649 on the bolt
holes at the end of the side handle.
12. Insert the side handle through the
lower and upper handle assembly, noting
the previous marks, you made,indicating
where the handle collars should be in-
stalled. Insert the 5/16" Socket Head Cap
Screws into the recess in the top handle
assembly.
13. Insert the 5/16" Socket Head Cap
Screws into the recess in the bottom
handle assembly.
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE
