HOLDEN VT Commodore Executive
Mount siren on the flat surface beside the fuse box in the engine bay. The plastic cable tray around the
strut tower has clips on its underside into which the siren loom will fit. Run the loom through clutch cable
grommet in the fire wall. Mount the bonnet switch in factory provided square hole in front of the centre
of the radiator. An extra bump stop must be fitted in the hole in the bonnet lid directly above the switch
cavity.
Pull down the drivers side dash panel. There are no screws. Remove the black plastic pin on the left hand
side to completely remove this panel. Undo four screws to remove the lower cover of the centre console
on the driver’s side. Mount the module on the metal bracket that is now exposed.
All wiring is available behind the driver’s side kick panel. Remove the cover strip in the tread plate to
expose four torx head screws. Remove them. Lift up the tread plate to expose a screw in the kick panel
and remove it. Remove one screw behind the bonnet release lever. Pull the kick panel out. Split the
wiring loom at the Y intersection.
There is no good position for the LED. A hole may be drilled below the head light switch, depending
upon customer preference.
POWER Orange/Black
EARTH
Connect to the vehicles chassis.
IGNITION Pink
LEFT BLINKER
Dark Blue
RIGHT BLINKER
Light Blue
DOOR White/Yellow
STARTER WIRE
FUEL PUMP WIRE
Thick Purple
