RHINO ENHANCER
™
ALARM SYSTEM FEATURES:
~ All Microprocessor Controlled
~ Ultra-Bright Red Flashing Light
~ Intelligent Pre-Alert Impact (Shock) Sensor with ETS™
~ Two Point Engine Immobilisation
~ Battery Backup System
~ Automatic Siren Reset Period (30 Seconds)
~ Arming and Disarming Confirmation Beep
~ Visual Arming and Disarming via Blinkers
~ Selectable Current Sensing Circuit
~ All Points of Entry Protection
~ Past Alarm Trigger PAT
™
Memory History Reporting Mode
~ Service and Override Mechanical Keyswitch
~ Safety Circuit Prevents Arming While Ignition On
~ World First Learning Mode for Installing the System
~
World First Poly Fuse Electronic Protection
TEACHING THE ENHANCER
™
TO THE VEHICLE:
FOLLOW THESE STEPS CAREFULLY.
1. Connect all wires shown in the wiring diagram except the yellow wire. (ie. Don’t
connect the ignition wire).
2. Install the siren in a position where it will be unlikely to get wet.
3. Plug the module into the loom. Please ensure that the siren keyswitch is turned to the off
position.
4. The vehicle’s existing immobiliser must be disarmed. (The vehicle should be unlocked).
5. Connect the yellow wire temporarily to +12V.
6. Turn the siren keyswitch on.
7. Arm the vehicle’s system via the remote control.
8. Wait longer than 10 seconds.
9. Then disarm the vehicle’s system via the remote control.
10.Wait longer than 10 seconds.
11.Repeat steps 7 to 10, ten (10) times.The siren will beep once to confirm completion. If
the Enhancer goes into siren mode, repeat steps 3 - 11 again.
12.Remove the yellow wire from +12V.
13.Arm the vehicle via the remotes. The Enhancer should now arm (1 Beep & 1 Flash).
14.Disarm the vehicle via the remotes. The Enhancer should now disarm (2 Beeps & 2
Flashes).
15.If the Enhancer did not arm/disarm then repeat steps 3-13, otherwise continue to step.
16.Connect the yellow wire to the vehicle’s ignition system as per wiring instructions.
WIRING INSTRUCTIONS
