Slide way of the
back shell
Snap joint of the
C shape buckle
of the back shell
Figure 1
Rotary hole
Rotation shaft of
the back shell
Figure 2
1. Control panel
14. Lower air duct
2. Horizontal louvre
15. Cable winding post
3. Vertical louvre
16. Drain cap
4. Air outlet frame
17. Evaporator filter mesh
5. Vertical Louvre connecting lever
18. Evaporator filter frame
6. Caster
19. Radiating fine mesh
7. Horizontal louvre connecting lever 20. Condenser filter mesh
8. Main vertical louver
21. Condenser filter frame
9. Front shell
22. Base plate
10. Handle position (right side: remote 23. Remote control
control storage area)
24. circular connector
11. Back shell
25. Heat exhaust hose
12. C shape buckle for the heat
26. Heat exhaust hose short connector
exhaust hose snap
27. Window sealing board assembly
13. Power cord
INSTALLATION ADJUSTMENT
1.
Installation
WARNING:
leave this mobile air-conditioner in an upright position for at least 2 hours before first
use. Ensure the air-conditioner in an upright position whilst moving . The air-conditioner should
be placed on a flat surface. Do not install or operate this air-conditioner in a bathroom or other
wet environments.
a)
Installation of the exhaust clip to the rear of the unit. (figure 1)
