12
must have a 1/2” (12.5mm) indent so stabber enters pile correctly. Be careful
not to allow the left stop rod (1) to block sensor beam (2).
5. Plunger Bracket: See illustration 10.1.
The plunger is used to add weight to the top of the pile. The only time it will be
necessary to use this is when a lift of paper slides forward as the stabber
enters the pile. Occasionally a lift of paper will slide forward as it enters the
pile even with the plunger on the paper. This usually happens when heavy
cover stock is being separated. This is normal. The lift that pushed forward of
the pile will be equal to the amount which would have been lifted. Insert this
into the punch or APES as you would normally do. Be careful not to allow
plunger (1) to block sensor beam (2), the machine will not pick paper.
6. Loading Paper:
Load up to 6” of paper with the top of the book facing the rear of the machine. If tabs
are being separated, jog the book on the binding edge and place the tabs against the
book stop plate. Try not to let the stack of paper and tabs become misaligned as you
place the stack in position.
Summary of Contents for Onyx PAL-14 Piks-A-Lift
Page 16: ...16 Schematics ...
