9
Mounting the PAL-14 onto an APES-14:
See illustration 7.0.
Make sure the APES is mounted on the HD punch before proceeding with this
step, refer to the APES manual.
Locate the APES module standoff kit. Remove the four long metal spacers (1)
and find the two short plastic spacers (2). The position of these standoffs will be
determined by the slots located on the APES base plate. There is no exact
location for these standoffs or which slots are used. Use the 3-winged knobs (3)
to secure the PAL-14 to the APES. The operator can choose a comfortable
working distance for the PAL-14 by choosing different mounting positions. The
long spacers will be used toward the rear of the PAL-14 base plate. There is a
threaded shaft protruding from one end of the long spacer. Insert this threaded
shaft through the slot of the APES, and screw it into the interface blocks
previously mounted on the HD punch. Use the same procedure for the front two
spacers except this time, insert the threaded shaft through the plastic washer
first, and then through the slots of the PAL-14. Only three knobs are actually
required, the knob that is located on the machine forward and right may be
removed if there is interference with the paper stack.
Summary of Contents for Onyx PAL-14 Piks-A-Lift
Page 16: ...16 Schematics ...
