7.2 Display
Note
Preset values are retained in each mode (standard or pro
selection)!
7.2.1 Overview of adjustable parameters
Note
Backlight changes depending on selected mode.
STROBO mode:
white
TACHO mode:
orange
Laser mode:
light-blue
When inactive, the backlight turns off automatically after approx.
10 seconds.
7.2.2 Standard selection (Figure 2 on page 2)
Note
Not all of the settings shown in figure 2 are available in standard
selection.
7
Operating instructions
RT STROBE pocketLED LASER
Set frequency
Select mode
Statistics
Set brightness
Set phase shift
Select trigger
Select frequency unit
Select brightness unit
Set delay
Set trigger divider
Set slow motion
Set trigger signal edge
Store parameter
Read parameter
Display
1/min / Hz / FPM
STROBO / TACHO
min / max / average
BRIGHT deg
PHASE deg
INT / EXT
1/min / Hz / FPM
BRIGHT deg / µs
DELAY ms
DIV.
SLOW
TRIG.
MEM in
MEM out
Standard
•
•
•
•
•
•
•
Without
Trigger
•
•
•
•
•
•
•
•
•
•
Pro
•
•
•
•
•
•
•
•
•
•
•
•
•
•
With
Trigger
•
•
•
•
•
•
•
•
•
•
•
•
•
•
TACHO
•
•
•
•
STROBO
Device
Set
value
•
•
•
•
•
•
•
•
Select
parameter
•
•
•
•
•
Functions of button Menu “M” (B)
No.
(7)
No.
(7)
Off
Display
resp. setting the
frequency
Mode
Display
-
Display
Adjustable
parameters
Adjustable
parameters
TACHO / STROBO
Description
Device is switched off.
Display resp. setting the
frequency frequency in 1/m,
Hz or FPM.
Change the frequency by
pressing the buttons “PLUS”
(E ), “MINUS” (D), “DIV” (F)
and/or “MUL” (G).
Description
Selection of the mode:
TACHO or STROBO
How to set the frequency:
1. Switch on the device by pressing the button “ON / OFF” (A) for at least 1 second.
→ The following will then appear in the display for a few seconds
▪ all settings followed by
▪ “S”, for standard selection
→ The following will then appear in the display:
2. Set the desired frequency by pressing the
buttons “PLUS” (E ), “MINUS” (D), “DIV” (F)
and/or “MUL” (G).
þ
This setting is now active.
How to select the mode:
1. Switch on the device by pressing the button “ON / OFF” (A) for at
least 1 second.
→ The following will then appear in the display for a few seconds
▪ all settings followed by
▪ “S”, for standard selection
→ The following will then appear in the display:
2. Press the button Menu “M” (B) to switch
between the different settings and operation
modes in the sequence of the display indica-
tor. Select the parameter you want to change
(e.g. STROBO/TACHO).
→ The following will appear in the display:
→ The active parameter flashes
3. Switch between the parameters by pressing the buttons “MINUS” (D) or
“PLUS” (E).
4. Press the button menu “M” (B) again to move to the next parameter.
þ
This setting is now active.