3. About these operating instrucions
These operating instructions are an integral part of the device. They
must be stored in an easily accessible location and passed on to
subsequent users. Ask your supplier if there is something you do
not understand.
Read the operating instructions thoroughly and follow the
instructions provided. These operating instructions contain
important information about installing, commissioning
and operating the stroboscope. Pay particular attention
to the safety information and warnings to prevent injuries
and product damage.
The manufacturer reserves the right to develop and update the
product continuously, without documenting all developments. Your
supplier will be pleased to provide information on the status of exis
-
ting operating instructions and on any alterations and extensions
that may be relevant.
3.1 Conventional representation in this document
3.1.1 Presentation of work instructions
Work instructions are shown in numbered steps and must be carried
out in the order stated.
1. Step
→ An arrow is used to show stroboscope reactions to a step.
2. Step
3. Step
The end of a work instruction is shown as follows:
þ
End of work instruction
A work instruction that only consists of one single step will appear
as follows:
► Step
4. Intended use
This device is used for inspecting the movement of rotating and
vibrating objects (STROBO mode) and for non-contact measurement
of rotational movements (TACHO mode). It may only be used in
accordance with these instructions. The device must not be opened.
Modifications to the device are not permitted. The manufacturer shall
not be liable for damage resulting from incorrect use or use contrary to
the intended use. Warranty claims will also be invalidated in this event.
Warning
Risk of injury!
Moving objects appear still or in slow motion in stroboscopic light.
Do not touch such objects under any circumstance.
Warning
Risk of injury!
The device may not be used in potentially explosive areas.
Warning
Risk of injury!
Stroboscopic light can trigger epileptic seizures in persons at risk.
Warning
Risk of injury!
Never direct the LED beam at people or animals and do not stare
directly at the beam.
Warning
Risk of injury!
Laser class 2
The stroboscope is fitted with a class 2 laser. This is located at the
LED array of this device. The laser beam can damage eyes.
For this reason, do not stare directly at the laser beam and never
direct it at people or animals. Wavelength: 650 nm, output: 1 mW
Caution
Flashing lights can cause retina damage!
The stroboscope is fitted with 6 LEDs. These produce
potentially dangerous optical radiation, which can cause
retina damage. Do not stare directly at the light and never
direct it at people or animals.
Caution
Warranty void!
The device may only be repaired by the manufacturer or by an
authorized supplier.
Caution
Correct disposal!
The electronic components in the device contain
environmentally harmful substances. They must be
disposed of in accordance with the environmental
regulations in the country of use.
Note
Suitable for use in residential, commercial and industrial area.
Note
Low risk (Risk group 1 – RG 1)
The brightness of the LEDs correspond to the risk group 1
according to DIN EN 62471:2009-03. The lamp resp. the light
represents no hazard for the user under normal behavioral
limitations.
5. Scope of delivery
Check that you have received all of the following:
▪ Stroboscope RT STROBE pocketLED LASER (device version
with trigger / device version without trigger)
▪ Operating instructions
▪ Calibration certificate
▪ Cable with plug for trigger signal (device version with trigger)
▪ Reflective tapes
▪ 6 x AA size disposal batteries
▪ Case
5
Operating instructions
RT STROBE pocketLED LASER