Page 14 of 22
14. Locate the three holes in the lamp connector end plate with the three holes on the end of the
sealing nut; screw all three 3mm screws through the holes in the end cap, into the sealing nut
(Picture 9).
B
UILDING MANAGEMENT SYSTEMS (BMS)
The Rheem UV disinfection power supply can output up to a 240V/2A voltage free signal to a BMS to
indicate lamp run and/or fail status.
Connecting between common (C) & Normal Open (NO) indicates RUN status.
Connecting between common (C) & Normal Closed (NC) indicates FAIL status
Connect a cable to the terminals marked VFC/NO, NC,C as required. Connect the wires to the BMS
system,
using an appropriate cable gland, following the BMS manufacturer’s recommendations.
Picture 7
Picture 8
end plate
Picture 9
