RH CGS-240, Manual

Page: 14 / 148

Installation
CGS-240 Manual 6/15/2021
Page 14 of 148
3.1.4 FLOOR SPACE
The system dimensions are 52 inches wide, 30 inches deep, 54 ½ inches high (1.3 m x 0.76 m x 1.4 m). For service
access and swing of the doors, the system should have 2 feet (0.6 m) of free space in the rear and on each side,
and approximately 2 feet (0.6 m) of space in the front.
The system is on casters and may be rolled into tight areas for use and rolled out for service. To secure the
system in place, the caster locks may be engaged, preventing the casters from rolling.
3.2 UTILITY CONNECTIONS
3.2.1 AC POWER CONNECTION
The system connects to AC power via the supplied 200-240V AC
Y-style power cable. Plug the two connectors into the system at
the rear panel (one into the upper cabinet receptacle and one
into the lower cabinet receptacle) then plug the other end into
your 200-240VAC power source.
Turning on the upper cabinet rear panel power switch applies
power to the upper cabinet only which houses the humidity
generator.
The lower cabinet rear panel power switch applies power to the
lower cabinet only which houses the air compressor system.
3.2.2 GAS SUPPLY CONNECTION WHEN UTILIZING SUPPLIED AIR COMPRESSOR
The lower cabinet houses the supplied air compressor. As shipped, a pneumatic connection is already made
between the lower and upper cabinets to supply the compressed air from the lower cabinet to the humidity
generator housed in the upper cabinet. This connection is via the short blue tube located between the rear panel
power switches.
Figure 3.1