Page 10 of 10
STEP #5
TODDLER RAIL ASSEMBLY
STEP #5.1:
Remove the rail frames of the crib by loosening all the bolts
installed as well as the mattress support.
STEP #5.2:
Gently tilt the crib and release the bolts underneath the metal
brackets holding the stabilizer rails.
NOTE:
If mattress support is not in the lowest position, loosen the
mattress support bolts and move to the lowest position.
STEP #5.3
On inside face of both side panels there is a cavity for the hook
which corresponds to the hooks on both ends of the toddler rails .
Align and insert the hook of the toddler rail into the cavity of the
side panel. See
DETAIL I
.
NOTE:
Fill the holes located on the top of both sides of the side
panel by inserting bolt (DD) provided.
STEP #5.4
Repeat step #3. Installation of stabilizer rails into the side panel
(
DETAIL J
).
NOTE:
After assembly, re-tighten all bolts to a snug fit.
DETAIL I
DETAIL J
DD
DD
DD
DD
BOLT 1/4" X 1/2" = 4 PCS
HARDWARE NEEDED FOR STEP #5:
ALLEN WRENCH = 1 PC
