Tiga User Manual
UM-Tiga-017-US
Tiga User Manual |
17
Procedure 11 - Sideguards
Procedure 11
Sideguards support the user and prevent clothes from getting
dirty. Although these need little maintenance, replacement is
shown below.
11.1: Screw in sideguards
Remove the rear wheels. Using a 4mm allen key from the
toolkit, release the 3 screws in the sideguard. To install, secure
all screws but do not tighten until all are in position. Take care
not to cross thread the screws.
11.2: Lift out sideguards
Remove sideguards from receiver. Using a 4mm allen key from
the toolkit, release the 2 screws securing the sideguard to the
lift out post. To install, replace and tighten the 2 screws. Take
care not to cross thread the screws.
11.3: Fold flat sideguards
Using a 3mm allen key from the toolkit, remove the 4
screws from the inside of the sideguard. To install, secure
all screws but do not tighten until all are in position. Take
care not to cross thread the screws.
11.4: Flip back sideguards
Using a 4mm allen key from the toolkit, release the screws
securing the sideguard to the lift out post. To install,
replace and tighten the 2 screws. Take care not to cross
thread the screws.
