Issue No: SQCA1 2010
12
STEP 5: Place the NEW ERGO Seat strap over the back of the seat and secure.
STEP 6: Place the NEW SUPPORT STRAP in the same place as the previous strap,
and secure.
STEP 7: Place the NEW SEAT SLING over the correct seat area and secure.
STEP 8: Adjust tension to suit.
STEP 9: Refit wheels and cushion.
4.3. SIDEGUARD
This section contains important information regarding replacement of the aluminium side
guard.
4.3.1. REPLACING ALUMINIUM SIDEGUARD
Follow the steps below to replace the side guard;
STEP 1: Remove wheels from the chair.
STEP 2: Release and remove locking handles
and washers, taking note of the washer
sequence,
see image 11
.
STEP 3: Remove 2 button head screws using
a 4mm Allen key and remove the side guard.
STEP 4: Identify correct placement with new
side guard.
STEP 5: Re-fit 2 button head screws and
tighten securely.
STEP 6: Refit and secure locking handles
ensuring the washers are in the correct
position.
STEP 7: Repeat for opposite side.
WARNING!
Ensure screws are securely fitted to frame. DO NOT over tighten screws to
prevent part damage.
4.4. QUICK RELEASE AXLE
The following section contains important information regarding the quick release axle
adjustment.
4.4.1. ADJUSTING QUICK RELEASE AXLE STROKE
Follow the steps to adjust the quick release axle;
STEP 1: Remove rear wheel and quick-release axle from the chair.
STEP 2: Press detent button in the quick-release axle and slide axle through the wheel
hub to separate.
Image 8: STEP 5
Image 9: STEP 6
Image 10: STEP 7
Image 11: Side guard (left)
Plastic
washer