RFS INSTALLATION GUIDELINES
HYBRIFLEX
®
CABLE|603400210500|September 2020
Visit
for the most current product specifications
Page 20 of 43
1-1/4 |1-5/8 inch Armor cutting tool instruction
The following instructions can be use for 1-
5/8” HYBRIFLEX cable. The cutting tool is a special design. An “off
the shelf” pipe cutter from local hardware store should
not
be used. Note:
This is not a combo tool; size must
be purchased as either 1-
5/8” or 1-1/4”,
To use the HTPT’s cutting tool to cut the outer armor,
1)
Using the jacket striping tool remove the jacket off the cutting section
2)
Turn the turning knob counter clockwise all the way until the tool is completely open (Figure 2).
Warning!
Do not try to release the latch, it
is locked in place. The blade can only be
moved in and out by tuning the knob.
3)
Insert the cable between roller 1 and
2 as shown in figure: 2.
4)
Grasp cable and tool together with
one hand as shown in figure: 2a
5)
Slowly spin tool around the cable
while rotating the knob continue until the
aluminum armor cut through. As shown in
figure: 3, 3a