Revision 06/2016
14190 E. Jewell Avenue Suite 4 Aurora CO 80012 TEL: 303-366-1234
www.rfidinc.com/activeRFID
ActiveRFID Operations Manual
33
Where:
000
= command
Receiver Response:
<LF>
0
DD
CS
<CR>
Where:
<LF>
= Line Feed
403
= command
DD
= decimal number of attenuation setting, valid from 00 to 62
CS
= Receiver generated checksum
<CR>
= Carriage Return
[
6
] – Ignore Tag command
This command causes the Reader to ignore a specific Tag number and is good only for a single Tag.
Host: [
6
DDDDDDDDDDDDDD
]
Where:
6
= command and
DDDDDDDDDDDDDD
= Tag number to ignore
Reader Response:
<LF>
6
DDDDDDDDDDDDDD
CS
<CR>
Where:
<LF>
= Line Feed
6
= command
DDDDDDDDDDDDDD
= Tag number to ignore
CS
= Reader generated checksum
<CR>
= Carriage Return
Note: Issuing the Ignore command will render all other commands unavailable for the same Tag
data. To release a Tag from being ignored, simply issue another
[
6
]
command for a fictitious
Tag.
[
X
] – Stop Data outputted from Reader
You must X to turn command off.
This command stops transmitting data between the Reader and the host. This is useful when you want to
command the Reader without data being sent. The [
X
] command for Factory Reset will start the
transmitting again between the Reader and the host.
Host: [
X
55
]
Where:
X
= command
55
= password, so no false shutdown occurs
Reader Response:
<LF>
X
CS
<CR>
Where:
<LF>
= Line Feed
X
= command
CS
= Reader generated checksum
<CR>
= Carriage Return
[
G
] – Read Tag Flag Data
Enter Tag you want to read the Flag data from and the Reader will output that
Tag’s
Flag Data. This
cannot be used for Wiegand output.
Host: [
G
DDDDDDDDDDDDDD
]
Where:
G
= command and
DDDDDDDDDDDDDD
= Tag you are specifying
Reader Response:
<LF>
G
DD
CS
<CR>
Where:
<LF>
= Line Feed
G
= command
DD
= two digit decimal number representing the Flag Data
CS
= Reader generated checksum
<CR>
= Carriage Return
[
71
] – Enable Relay
This command enables the relay, closes the contacts.
Host: [
71
]