The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V..
QIG_L-gateway_v1.20
Page: 9(
12)
6 Mounting Diagram
To mount the L-gateway onto a vertical pole attach the U-bolts (no. 1) to the brackets (no. 2),
then slide the completed enclosure assembly over the pole.
Adjust the L-gateway enclosure to the desired position on the pole (up and down or rotational).
Use a nut wrench to tighten the U-bolts (no.3) and secure the L-gateway enclosure in place.
Tighten all four nuts. When tightening the U-bolts, ensure that the bolts are not twisted. The
ends of each U-bolt should be protruding through the bracket evenly at the same distance.
Figure 1: U-bolt assembly
Check that the U-bolts are tight and that the L-gateway enclosure is securely anchored to the
pole.
