The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
Page: 10(
21)
5.
Insert the SIM card with the connections facing downwards into the SIM card holder. Pay
attention to the correct position. The SIM card has a small cut off corner which located
on the top left corner in the picture below.
6.
Re-assemble the unit, taking the above steps in reverse order.
After insertion of the SIM card and reassembly of the unit you can start configuring the unit.
3.2 Connecting the G-router Unit to your network
A.
Connect an Ethernet cable to the port labeled “
Eth0(POE)
” on the RFI G-router.
B.
Connect the other end of the Ethernet cable to the port labeled “
J1 Data & PWR
” on the
Power-over-Ethernet (PoE) power supply.
C.
Connect the port labeled “
SERIAL
” to the WAN router you want to monitor.
D.
Connect the power cable to the back of Power-over-Ethernet (PoE) and power the unit
on.
When you have completed the above steps the connected network should look like this:
Figure 3: G-router Connections
Cut-off corner
