R.F. Technologies, Inc. • 9
1.
2.
3.
4.
5.
6.
7.
Press MENU button on bottom left hand of screen.
8.
Press VOLUME ADJUST button on bottom left hand of screen.
9.
Press CEILING SPEAKER.
10. Highlight INBOUND AUDIO.
11. Use UP arrow to raise volume to 15.
12. Press BACK button 3 times to show the main screen.
Panasonic UltraPlex
1.
Press and release on top of center module cover to unlatch. Allow cover to swing down and expose settings.
2.
Feed audio cable behind center module and through cutout.
3.
Locate “REMOTE SP.”
4.
Using a small, flathead screwdriver, secure red wire into positive (H) terminal.
5.
Using a small, flathead screwdriver, secure black wire into negative (C) terminal.
6.
Locate black volume knob labeled “REMOTE SP VOLUME” and adjust to approximately 7.5.
7.
Remove cover above volume control knobs to gain access to settings.
8.
Ensure switches 2 (Menu Mic) & 3 (Talk On) are in the “ON” position.
9.
Replace settings cover.
10. Close main cover of center module.
Panasonic UltraPlex II
1.
Pull down on top of center module cover to unlatch. Allow cover to swing down and expose settings.
2.
Feed audio cable behind center module and through cutout.
3.
Locate “REMOTE SPEAKER.”
4.
Using the small, flathead screwdriver, secure red wire into positive (H) terminal.
5.
Using the small, flathead screwdriver, secure black wire into negative (GND) terminal.
6.
Locate black volume knob labeled “REMOTE SP” and adjust to approximately 7.5.
7.
Above volume knob, locate settings “REMOTE.”
8.
Ensure that TALK and BEEP are in the ON position.
9.
Close main cover of center module.
Panasonic Attune I (3050 Headset)
1.
Gently push in and pull down to remove cover of base station and expose wires.
2.
Feed audio cable behind center module.
3.
Using the small, flathead screwdriver, secure red wire into leftmost terminal.
4.
Using the small, flathead screwdriver, secure black wire into the space next to the red wire.
5.
Locate the INSTALL SYSTEM SETTING area at the top of the center module.
6.
Ensure the TALK and BEEP light are green. Skip to step 7 if lights are green.
a. Press the [NEXT] button twice to make the TALK light blink.
b. Press the [SEL] button once.
c. Press the [NEXT] button twice to make the BEEP light blink.
d. Press the [SEL] button once.
7.
Locate the black AUX SP volume control knob.
8.
Adjust volume level to 7.
