background image

R.F. Technologies, Inc. • 2

WARNINGS AND DISCLAIMERS

• 

Danger of explosion if battery is incorrectly replaced. Replace only with the same or 
equivalent type.

• 

To reduce the risk of electric shock, do not perform any servicing other than that contained 
in the operating instructions.

• 

Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.

• 

Do not use this apparatus near water.

• 

Clean only with dry cloth.

• 

Do not install near any heat sources such as radiators, heat registers, stoves, or other 
apparatus (including amplifiers) that produce heat.

• 

Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, 
and the point where they exit from the apparatus.

• 

Only use attachments/accessories specified by the manufacturer.

• 

Unplug this apparatus during lightning storms or when unused for long periods of time.

• 

Refer all servicing to qualified personnel. Servicing is required when the apparatus has 
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been 
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or 
moisture, does not operate normally, or has been dropped.

• 

In no event shall R.F. Technologies, Inc. be liable to any party or any person, except for 
replacement or reasonable maintenance of the product, for the cases, including but not 
limited to below:

1. 

Any damage and loss, including without limitation, direct or indirect, special, 
consequential or exemplary, arising out of or relating to the product;

2. 

Personal injury or any damaged caused by inappropriate use or negligent 
operation of the user;

3. 

Unauthorized disassemble, repair or modification of the product by the user;

4. 

Any problem causing failed signal transmission resulting in consequential 

          inconvenience, loss or damage, arising out of causes such as system                 
          malfunction, fault, set up or installation;
5. 

Any problem consequential inconvenience, or loss or damage, arising out of the 
system combined by the devices of third party;

6. 

Personal injury, any loss or damage, arising out of the drop caused by the 
incomplete installation;

7. 

Loss of registered data caused by any failure;

• 

The apparatus should not be exposed to dripping or splashing and that no objects filled 
with liquids, such as vases, should be placed on the apparatus;

• 

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such 
as sunshine, fire or the like.

Summary of Contents for LIO LIODP Series













Reviews: