R.F. Technologies, Inc. • 6
1.4 Registering LIO Belt Pack to LIO Base
1.
Turn off all other LIO Belt Packs (even if
they have not been registered yet).
2.
Unplug power from LIO Base and plug back in.
3.
Hold down the power button on LIO Base
for approximately 3-seconds. The “fast
blink” pattern on the LIO Base should
appear. (Figures 9 & 10) (Table 4)
4.
Insert battery into LIO Belt Pack.
5.
Press power button on LIO Belt Pack to turn on.
6.
Hold down power button on LIO Belt Pack
for approximately 3-seconds. The “fast
blink” pattern on the LIO Belt Pack should
appear. (Figures 11 & 12) (Table 4)
7.
Wait until the LED on both the LIO Base and
LIO Belt Pack appear solid. This should take just
a few seconds, but could take up to one minute.
8.
Plug earstick into LIO Belt Pack. (Figure 13)
The LIO Belt Pack and LIO Base are now registered.
Any audio applied to the LIO Base can be heard in
the earstick connected to the LIO Belt Pack.
*NOTE: Any stereo 3.5mm wired earphone is
compatible with LIO Belt Packs.
A single LIO Belt Pack can be registered to a
maximum of 4 LIO Bases at one time. If a LIO
Belt Pack is registered to a 5th LIO Base, the 1st
registered LIO Base is replaced.
A single LIO Base can register a maximum of
21 LIO Belt Packs. The 22nd LIO Belt Pack will
not register to the LIO Base. If this occurs, you
must follow the Clearing Registrations process in
section 2.2 for the LIO Base and re-register any
LIO Belt Packs you wish to be registered to the
LIO Base.
(Figure 12)
(Figure 11)
3 seconds
3 seconds
(Figure 9)
(Figure 13)
(Figure 10)
