SCORPION LoRa Transmitter
DS-SCORPION-1 Page 9
When a switch button is operated SCORPION will
transmit a “Button Down” RF Transmission
When a switch button is released SCORPION will
transmit a “Button Up” RF Transmission
Continuous Transmit
SCORPION repeat transmits “button Down” in short
bursts for as long as switch button is pressed.
If the Acknowledgment is ON the receiver will reply
after each RF transmission burst.
This is ideally suited to momentary operation where
the receiver output needs to be active as long as the
user presses down a SCORPION Button .
State Change Transmit
SCORPION transmits an RF transmission only when
the switch button is pressed or released (i.e a state
change).
On each of these “state changes” SCORPION trans-
mits upto 4 transmissions, or, “RF packets” (which
can be seen by the GREEN LED flashing upto 4 times,
If the Acknowledgment is ON the receiver will reply
immediately.
After receiving an Acknowledgment the SCORPION will
cease sending any remaining of the 4 transmissions.
.
.
Press SET Sw
4X
LED1
flashes 4x
LED 1 & 2
Flashes 1x
LED1 is either
ON or OFF
indicating
current Status
Repeat Press SET Sw To
select
LED1 OFF: State
LED1 ON: Continuous
After selecting wait for timeout
Wait 3 Seconds
Wait 3 Seconds
To Set Continuous or State Change RF Transmissions
