EZTEXT
DS-EZTEXT-6
User set-up commands
Title
Command
Description
Example
Password
UPW
UPW#UNITPW
User must send UPW command within 5 mins after
power applied. Setting the UPW is carried out by send-
ing this text message to the unit.
The User Password (4
–
8 Characters) is case sensitive
and can consist of any letters or numbers.
If for any reason the unit password is lost, remove all
power for 1 minute, and then start again.
Note : Default password is 1234
UPW#1234
(sets password to
1234)
Response:
UPW OK
Unit identity
UID
UNITPW#UID#UNITID
This sets the ‘identity’ of the EZTEXT unit, and will be
included in any response text from EZTEXT.
The UNITID can be 4 to 10 characters.
1234#UID#Door Alarm
Response:
Door Alarm UID OK
Response
RESPONSE
RESPONSE?
UNITPW#RESPONSE#x
Setup a Reply Text EZTEXT after receiving a command
x=ON or OFF
UNITPW#RESPONSE?
Requests the status of the current RESPONSE setting
NOTE: messages which specifically demand a response
such as requests for input status will always be re-
sponded to as will the UPW, UID etc.
Default setting is for response to be turned ON.
1234#RESPONSE#ON
Turns on Response
messages
1234#RESPONSE?
Replies with the EZ-
TEXT setting to re-
sponses
Text Message Commands
Error Messages and Factory Reset
There are three error messages;
NO AUTHORISATION
Means that EZTEXT did not accept the password
UNRECOGNIZED COMMAND
Password correct but the command is incorrect
UNRECOGNIZED VARIABLE
Password and command OK but the variable data is in-
correct
Factory reset
Hold down the RESET button for approx10
seconds until all LEDs flash, then release.
This will reset EZTEXT to factory default
settings and restart.
Please note that the following characters can be used as character separators
Has h“#”, Comma “,” or Space “ “
For example
1234#out1#ON or 1234,out1,ON or 1234 out1 ON
Reset switch
