Reznor LDAP, Installation Operation & Maintenance

Page: 38 / 48

38 LDAP-IOM (01-22) 207733-A
Table 18. Inputs and Capacities by Elevation in US
Elevation
(Feet (Meters))
Unit Size
400 800 1200
Normal
Input
Thermal
Output
Capacity
Minimum
Input
Normal
Input
Thermal
Output
Capacity
Minimum
Input
Normal
Input
Thermal
Output
Capacity
Minimum
Input
BTUh
0–2000
(0–610)
400,000 332,000 300,000 800,000 664,000 400,000 1,200,000 996,000 400,000
2001–3000
(611–915)
376,000 312,080 282,000 752,000 624,160 376,000 1,128,000 936,240 376,000
3001–4000
(916–1220)
368,000 305,440 276,000 736,000 610,880 368,000 1,104,000 916,320 368,000
4001–5000
(1221–1525)
360,000 298,800 270,000 720,000 597,600 360,000 1,080,000 896,400 360,000
5001–6000
(1526–1830)
352,000 292,160 264,000 704,000 584,320 352,000 1,056,000 876,480 352,000
6001–7000
(1831–2135)
344,000 285,520 258,000 688,000 571,040 344,000 1,032,000 856,560 344,000
7001–8000
(2136–2440)
336,000 278,880 252,000 672,000 557,760 336,000 1,008,000 836,640 336,000
8001–9000
(2441–2745)
328,000 272,240 246,000 656,000 544,480 328,000 984,000 816,720 328,000
9001–10,000
(2746–3045)
320,000 265,600 240,000 640,000 531,200 320,000 960,000 796,800 320,000
ADJUSTMENTS—CONTINUED
Measure and Adjust Manifold (Outlet) Gas Pressure—Continued
Measure and Adjust Manifold Gas Pressure—Elevation >2,000 Feet (>610 Meters)—Continued
MAINTENANCE
The unit is designed to operate with a minimum of maintenance . However, to ensure long life and satisfactory
performance, routine service is recommended . When servicing, follow standard safety procedures and those specific
instructions and warnings in this manual .
⚠ DANGER ⚠
• If you turn OFF the electrical power supply, turn OFF the gas.
• To prevent injury or death due to electrocution or contact with moving parts, lock disconnect
switch open.
⚠ WARNING ⚠
• Eye protection is recommended when cleaning unit.
• When any service is completed, ensure that the unit is reassembled correctly so that no unsafe
conditions are created.
• When re-lighting, always follow the lighting instructions on the heater.
⚠ CAUTION ⚠
• If any of the original wire supplied with the appliance must be replaced, it must be replaced with
wiring material having a temperature rating of at least 105°C, except for limit control, flame rollout,
and sensor lead wires which must be rated at 150°C.
• If replacement parts are required, use only factory-authorized parts.