Euro-C 4000 RJL-GBEN
2/26
Table of Contents
1.0 INTRODUCTION
1.1
Basic Information
1.2
Warranty
2.0 TECHNICAL DATA
3.0 GENERAL REQUIREMENTS
3.1
Related Documents
3.2
Heater Location
3.3
Minimum airflow requirement
3.4
Compartment dimensions
3.5
Maximum airflow conditions
3.6
Electrical Supply
3.7
Gas Supply
4.0 INSTALLATION
4.1
Uncrating and Preparation
4.2
Electrical Connection
4.3
Room Thermostat Siting
5.0 COMMISSIONING AND TESTING
5.1
Electrical Check
5.2
Gas Connection
5.3
Lighting the Heater
5.3.1 To Turn the Heater ON
5.3.2 To Turn the Heater OFF for Short Periods
5.3.3 To Turn the Heater OFF for Long Periods
5.4
Heater Pipework
5.5
Adjustments
5.6
Air Heater Controls & Operation
5.7
Options
5.7.1 2 stage burner control
5.7.2 Modureg V7335A 2000 series modulation
system
5.8
Handing Over
6.0 SERVICING INSTRUCTIONS
7.0 REMOVAL AND REPLACEMENT OF PARTS
7.1
Main Burner Removal
7.2
Main Burner Injectors
7.3
Ignition System
7.4
Operating Gas Valve
7.5
Limit Controls
7.6
Combustion Air Pressure Switch
7.7
Combustion Air Fan
8.0 FAULT FINDING
9.0 PARTS LIST
10.0.GAS CONVERSION
11.0 USERS INSTRUCTIONS
12.0 HEALTH & SAFETY STATEMENT
HAZARD INTENSITY LEVELS
1.DANGER: Failure to comply will result in severe
personal injury or death and/or property
damage.
2.WARNING: Failure to comply could result in
severe personal injury or death and/or property
damage.
3.CAUTION: Failure to comply could result in minor
personal injury and/or property damage.
WARNING:
The electrical isolator should only be used in an
emergency and should not be used for closing
down the main burner, as it switches off the fan
prematurely and may damage the heat exchanger,
invalidating the warranty.
1.0 INTRODUCTION
1.1 Basic Information
The instructions in this manual apply to Model
EURO-C 4000 RJL gas-fired/fan-assisted warm air
heaters suitable only for incorporation in air
handlers built for outdoor installation. This
appliance must be installed in accordance with the
rules in force. Before installation, check that the
local distribution conditions, nature of gas and
pressure and adjustment of the appliance are
compatible.
A permanent electricity supply of 230 volts, 50 Hz,
single phase is required.
Model EURO-C 4000 RJL heaters are approved for
outdoor or rooftop application.
Category II
2H3+
These instructions are only valid for the countries
Great Britain (GB) and the Republic of Ireland (IE).
Check that the local distribution conditions of
electricity supply, type of gas and pressure of the
appliance are compatible.
