English
It
aliano
15
c.
Button Cable:
For this cable 3 options are available:
Cable for Push button 062.8219.-- (10 m)
Push Cable + Connector 062.8222.-- (10 m)
Push button with LED + Cable + Connector 062.8547.-- (10 m)
To make your selection, see section 1.4.
Step 6: Cut Timing Belt to length
The timing belt should be cut with an overlength for easy assembly. The length
must be calculated with the following formula:
Length (in meters) = (Vent stroke length (in meters) x 2) + 2
Step 7: Place Timing belt in the profile.
This can best be achieved by pushing the belt from the motor milling towards
the return pulley milling.
Make sure the teeth are pointing upwards (outwards to the opening) and the
belt is not twisted inside the profile.
Have both ends meet in the middle of the vent stroke.
DO NOT CUT THE BELT TO LENGTH AT THIS POINT!
Step 8: Assemble the motor holder clamp, adjust the depth of the screw
fixing plate according to the wall thickness of the profile.
Summary of Contents for 062.8251
Page 28: ...28 ITALIANO ...
