38
39
Appendix
If you feel pain or discomfort:
Remove both feet from the foot-pads to stop the stimulation.
Lower the intensity of the foot-pads using the intensity control on the control panel
before replacing your feet on Revitive.
e The foot-pad program will run for 30 minutes. You cannot change this time.
To pause stimulation remove both feet from the foot-pads, when ready to resume
stimulation place both feet back onto the foot-pads and press the intensity
control button.
Note that if paused for 10 minutes, the stimulation session ends and Revitive powers
off. You will hear three beeps when your Revitive switches off.
To stop stimulation, turn Revitive off by pressing the power button on Revitive.
b Press the power button on Revitive to turn it on.
c You will hear a beep and the display lights will light
up. The time will read 30 minutes and the
Intensity will read 00.
Press the Intensity Control button on the control
panel to start stimulation. The Time Display will
start to count down in minutes as Revitive cycles
through its program.
Press the to increase the level.
Press the button to decrease the level.
It is normal to feel tingling or varying sensations in
your feet and calf muscles.
Revitive does
not vibrate.
d Ensure you familiarise yourself with the feeling of Electrical Muscle Stimulation (EMS).
Use on a low intensity, for 30 minutes once per day or two 30-minute sessions a day,
for a few days.
Set the intensity at a level where you can feel the stimulation in your feet which
creates a calf contraction causing Revitive to rock back and forth on its IsoRocker.
After a few days of familiarisation, use a higher intensity that provides you with
strong but comfortable calf muscle contractions.
Most people experience a strong contraction at intensity level 40 or over. You can set
the intensity between 1 and 99.
Please note that the intensity required may vary from day to day.
30
5610_IFU02_17816222_PRINT.indd 38-39
5610_IFU02_17816222_PRINT.indd 38-39
21/01/2021 11:12
21/01/2021 11:12
