Reval RUBIS 3017.00, Instruction Manual, Page: 8 / 14

DIRECTIONS FOR USE
HEATING OF WATER
To start heating the water, turn on the button located near the temperature
controller.
The temperature of the water will rise gradually until the set temperature is reached
without exceeding it.
Heating time is 12min to reach 37
°
from 23
°
cold water.
Heating time is 6 min to reach 37
°
from 32
°
lukewarm water.
FITTING THE SHOWER SHEET
Put the shower sheet over the mattress underneath the individual.
Fix the shower sheet to the bed using the 4 spring clamps supplied.
SHOWERING
ATTENTION: Turn off the water heater when the required temperature is reached and before showering the individual.
ATTENTION: Check the water temperature before applying the showerhead to the individual.
Take the handheld shower.
Check that the flow intensity valve is opened.
Switch on the the shower pump by turning the button.
Adjust the shower flow intensity using the control panel.
Shower time is 2 minutes at non-stop max flow.
NOTE: Switch off the pump when the handheld shower is not being used.
DRAINING MATTRESS
Switch on the drainage pump by turning the button.
Waste water is pumped from the shower sheet to the waste water tank.
NOTE: Before switching off the pump, check the flexible hose does not contain
residual water.
DRAINING TANKS
Both tanks must be totally drained to ensure that no water stagnates inside.
Each tank has a flexible hose with valve to drain the water directly into a lavatory.
NOTE: Close the valves after the tanks have completely drained.
7/12