DIRECTIONS FOR USE
SHOWER
ATTENTION: Check the water temperature before applying the showerhead to the individual.
Take the handheld shower.
Switch on the shower pump by pushing on the On/Off button.
A LED indicator ignites.
The shower running time is 4 minutes 35s for an unbroken operation.
When the water level reaches 1/3 of the tank, the orange LED indicator will ignite, indicating that it stays approximately
1min 30s of shower time.
When the tank is empty, the red LED indicator ignites.
SECURITY : Check the water temperature before applying the showerhead to the individual.
DIGITAL SHOWER THERMOMETER
DRAINING MATTRESS
Take the suction pipe located behind the system.
Position the pipe on the mattress and if possible for a place where forms a pocket of water.
Switch on the drain pump by pushing on the On/Off button.
A LED indicator ignites.
Waste water is pumped from the shower sheet to the waste water tank.
NOTE : Before switching off the pump, check the flexible hose does not contain residual water.
10/16
Usage
: When the shower pump is activated, the display shows the water temperature. If
the water temperature is higher than 41°C, the LED warning lights flash red, the display
flashes and an acoustic warning sounds. When the water temperature drops below 41°C,
the thermometer reverts back to a normal status.
Energy saving mode
: The thermometer has an automatic energy saving mode. After
using the unit the thermometer automatically switches off after around 60 minutes. By
moving the thermometer, the energy saving mode in interrupted and the display is
automatically re-activated.
